Greasing The Steering Head Bearing; Removing The Start Number Plate; Installing The Start Number Plate; Removing The Front Fender - KTM 85 SX 19 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.13

Greasing the steering head bearing

11.14

Removing the start number plate

11.15

Installing the start number plate

11.16

Removing the front fender

11.17

Installing the front fender

x
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
800010-10
–
Remove screw
–
Remove screw
L00049-11
–
Position the start number plate. Mount and tighten screw
Guideline
Remaining screws, chassis
Info
Make sure that the holding lugs engage in the fender.
–
Position the brake line and clamp. Mount and tighten screw
L00049-10
–
Remove screws
L00040-10
–
Ensure that the spacers are mounted in the fender.
–
Position the front fender. Mount and tighten screws
Guideline
Remaining screws, chassis
Info
Make sure the holding lugs engage in the start number plate.
L00040-10
( p. 35)
x
( p. 36)
x
and take off the clamp.
1
. Take off the start number plate.
2
. Remove the front fender.
1
.
1
M6 10 Nm (7.4 lbf ft)
.
2
.
1
M6 10 Nm (7.4 lbf ft)
39