Adjusting The Chain Guide; Checking The Frame; Checking The Swingarm; Checking The Routing Of The Throttle Cable - KTM 85 SX 19 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.38

Adjusting the chain guide

11.39

Checking the frame

11.40

Checking the swingarm

11.41

Checking the routing of the throttle cable

x
–
Loosen screws
Condition
Number of teeth: ≤ 44 teeth
–
Insert collar bushing
–
Mount and tighten screw
Guideline
Remaining screws, chassis
Condition
Number of teeth: ≥ 45 teeth
–
Insert collar bushing
–
Mount and tighten screw
Guideline
Remaining screws, chassis
L00078-10
x
–
Check the frame for cracking and deformation.
» If the frame exhibits cracking or deformation due to a mechanical impact:
–
Change the frame.
401542-01
x
–
Check the swingarm for damage, cracking, and deformation.
» If the swingarm shows signs of damage, cracking, or deformation:
–
Change the swingarm.
401543-01
Preparatory work
–
Remove the seat. (
–
Remove the fuel tank.
Main work
–
Check the routing of the throttle cable.
The throttle cable must be routed to the carburetor behind the handlebars and
above the fuel tank bearing.
» If the throttle cable is not routed as specified:
–
Correct the routing of the throttle cable.
L00083-10
. Remove screw . Swing the chain guide down.
1 2
into drill hole
3
. Tighten screw
2
into drill hole
3
. Tighten screw
2
x
Info
A frame that has been damaged due to a mechanical impact must
always be changed. Repair of the frame is not authorized by KTM.
x
Info
A damaged swingarm must always be changed. Repair of the
swingarm is not authorized by KTM.
p. 40)
( p. 44)
x
. Position the chain guide.
A
.
1
M6 10 Nm
(7.4 lbf ft)
. Position the chain guide.
B
.
1
M6 10 Nm
(7.4 lbf ft)
49