Preparing For Rides On Dry Sand; Preparing For Rides On Wet Sand - KTM 85 SX 19 Owner's Manual

7 PREPARING FOR USE
7.4

Preparing for rides on dry sand

7.5

Preparing for rides on wet sand

–
Check the radiator cap.
Value on radiator cap
» If the displayed value does not meet specifications:
L00021-10
–
Change the radiator cap.
–
Fit a dust cover on the air filter.
Dust protection device for air filter (59006019000)
Info
See the KTM PowerParts fitting instructions.
B00435-01
–
Fit a sand cover on the air filter.
Sand protection device for air filter (59006022000)
Info
See the KTM PowerParts fitting instructions.
–
Adjust the carburetor jetting and the setting.
Info
B00436-01
Your authorized KTM workshop can recommend the right carburetor tuning.
–
Clean the chain.
Chain cleaner (
–
Fit the steel sprocket.
Tip
Do not grease the chain.
–
Clean the radiator fins.
–
Straighten bent radiator fins carefully.
600868-01
–
If used in sand regularly, replace the piston every 10 operating hours.
–
Check the radiator cap.
Value on radiator cap
» If the displayed value does not meet specifications:
L00021-10
Warning
Danger of scalding During motorcycle operation, the coolant gets
very hot and is under pressure.
–
Do not remove the radiator cap, radiator hoses or other cooling
system components when the engine is hot. Allow the engine
and cooling system to cool down. In case of scalding, rinse
immediately with lukewarm water.
p. 87)
Warning
Danger of scalding During motorcycle operation, the coolant gets
very hot and is under pressure.
–
Do not remove the radiator cap, radiator hoses or other cooling
system components when the engine is hot. Allow the engine
and cooling system to cool down. In case of scalding, rinse
immediately with lukewarm water.
1.8 bar (26 psi)
1.8 bar (26 psi)
17