Filling Up With Gear Oil; Adding Gear Oil - KTM 85 SX 19 Owner's Manual

16 MAINTENANCE WORK ON THE ENGINE
16.4

Filling up with gear oil

Info
Too little gear oil or poor-quality gear oil results in premature wear of the transmission.
16.5

Adding gear oil

Info
Too little gear oil or poor-quality gear oil results in premature wear of the transmission.
Main work
–
Remove gear oil drain plug
–
Completely drain the gear oil.
–
Clean the gear oil drain plug with the magnet thoroughly.
–
Clean the sealing area on the engine.
–
Mount the gear oil drain plug with magnet and the seal ring and tighten it.
Guideline
Oil drain plug with magnet
L00075-10
x
Main work
–
Remove the screw cap
Gear oil
–
Mount and tighten screw cap
L00072-11
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the gear oil level. (
x
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
Main work
–
Remove the screw
L00075-11
–
Remove screw cap
–
Add gear oil until it flows out of the bore of the gear oil level screw.
Engine oil (15W/50) (
–
Mount and tighten the screw in the opening used to check the gear oil level.
Guideline
Screw, engine case
–
Mount and tighten screw cap
L00072-10
with magnet.
1
and fill up with gear oil.
1
0.50 l (0.53 qt.)
.
1
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result
in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
p. 72)
from the opening used to check the gear oil level.
1
.
2
p. 85)
.
2
M10 20 Nm
(14.8 lbf ft)
Engine oil (15W/50) ( p. 85)
M6x25 10 Nm (7.4 lbf ft)
73