Handlebar Position; Adjusting The Handlebar Position - KTM 85 SX 19 Owner's Manual

10 TUNING THE CHASSIS
10.14

Handlebar position

10.15

Adjusting the handlebar position

Warning
Danger of accidents Handlebar breakage.
–
If the handlebar is bent or straightened it will cause material fatigue, and the handlebar can break. Always replace handle-
bar.
Info
Turn clockwise to increase damping; turn counterclockwise to reduce damp-
ing.
On the upper triple clamp, there are two holes at a distance of
Hole distance A
The holes on the handlebar support are placed at a distance of
Hole distance B
The handlebar can be mounted in four different positions. In this way, the handlebar
can be mounted in the position that is most comfortable for the rider.
C00248-10
x
–
Remove the four screws
and lay it to one side.
Info
Protect the motorcycle and its attachments against damage by covering
them.
Do not bend the cables and lines.
–
Remove the two screws
–
Place the handlebar support in the required position. Fit and tighten the two
C00249-10
screws .
2
Guideline
Screw, handlebar support
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamps. Fit and evenly tighten the four screws
Guideline
Screw, handlebar clamp
Info
Make sure the gap width is even.
15 mm (0.59 in)
3.5 mm (0.138 in)
. Remove the handlebar clamp. Remove the handlebar
1
. Remove the handlebar support.
2
M10 40 Nm
(29.5 lbf ft)
M8
31
to each other.
A
from the center.
B
Loctite 243™
®
.
1
20 Nm
(14.8 lbf ft)