Freestanding Installation - Juniper ERX-1410 Installation And User Manual

Freestanding Installation

This section provides instructions for installing the system on a table top
or in any other freestanding mode. See
for information about site requirements.
Figure 2-4 ERX-1400 series front view
Warning: Two people are required to lift an ERX system. The system is extremely
heavy.
To install the system as a freestanding device:
1
One person should stand on the left side of the system, and the other
should stand on the right side.
2
Grasp the lower back of the unit with one hand and the front flange
(see Figure 2-4) with the other.
3
Bend your knees and carefully lift the unit into position.
4
Carry the system to the location where it will operate.
Caution: Leave enough space around the system for adequate ventilation. See
Appendix A, System Specifications, for details.
5
Position the router with easy access to the connections that it needs
for power, local communications, and remote communications.
Note: Connectors are located on the I/O modules and the power input module.
See Figure 2-5. You install these modules from the rear of the router. See
Chapter 4, Cabling the ERX
Appendix D, Preparing Your
System, for cabling installation procedures.

Freestanding Installation

ERX Edge Routers
Site,
2-5