ENGINE REASSEMBLY
The engine reassembly can be performed in the reverse order of disassembly procedures. However, the
following points must be observed in the reassembly operation.
7
* Make sure to coat the rotating and sliding sections with engine oil.
* Care must be taken so that the drive belt, drive face and driven face are completely free from
oil and grease.
Starter clutch
Generator
80 N . m
(8.0 kgf . m)
Generator rotor
10 N . m (1.0 kgf . m)
Piston No.1
Conrod No.1
Bearing
66.9 – 67.1 mm
Piston pin
Conrod No.2
Washer
Primary drive gear
Crank pin
The Convex side of the
washer faces outside.
ENGINE 3-49
70 N . m (7.0 kgf . m)
[Left hand threads]