Suzuki VL125 Service Manual page 192

6-16 ELECTRICAL SYSTEM
TURN SIGNAL/SIDE-STAND RELAY REMOVAL
The turn signal/side-stand relay is composed of the turn signal
relay, and the side-stand relay and diode.
• Remove the luggage box. (!5-2)
• Remove the turn signal/side-stand relay 1.
SIDE-STAND RELAY INSPECTION
First check the insulation between D and E terminals with the
tester. Then apply 12V to terminals D and C (+ to D and -
to C) and check the continuity between D and E. If there is no
continuity, replace the turn signal/side-stand relay with a new
one.
DIODE INSPECTION
Measure the voltage between the terminals using the multi cir-
cuit tester. Refer to the following table.
Unit: V
" 09900-25008: Multi circuit tester set
) Tester knob indication: Diode test (*)
NOTE:
If the multi circuit tester reads under 1.4 V when the tester probes
are not connected, replace its battery.