Reassembly And Remounting - Suzuki VL125 Service Manual

5-48 CHASSIS
SWINGARM PIVOT SPACERS AND DUST SEALS
Inspect the swingarm pivot spacers and dust seals for damage. If
any defects are found, replace the spacer with a new one.
SWINGARM NEEDLE BEARINGS
Insert the spacers into the needle bearings, rotate the spacer and
check for abnormal noise and smooth rotation.
If there is anything usual, replace the bearing(-s) with a new one.
• Remove the swingarm needle bearings using the special tool.
% 09921-20220: Bearing remover set ( φ φ φ φ φ 20 mm)
7
The removed bearings should be replaced with new ones.

REASSEMBLY AND REMOUNTING

Reassemble and remount the swingarm and rear shock absorber
in the reverse order of removal and disassembly.
Pay attention to the following points:
72 N . m
(7.2 kgf . m)
• Press the needle bearings into the swingarm pivot using the
special tool.
% 09941-34513: Bearing/Steering race installer
• Apply the grease to the needle bearings and spacers.
/ 99000-25010: SUZUKI SUPER GREASE "A"
Left
Spacer
Right