Primary Drive Gear - Suzuki VL125 Service Manual

PRIMARY DRIVE GEAR

• Install the primary drive gear 1, washer 2 and primary drive
gear nut.
NOTE:
* The convex side of the washer 2 faces outside.
* The primary drive gear nut has left hand threads.
* When tightening the primary drive gear nut, install the key and
generator rotor temporarily.
• With the generator rotor held immovable using special tool,
tighten the primary drive gear nut.
% 09930-44530: Rotor holder
" Primary drive gear nut: 70 N . m (7.0 kgf . m)
PRIMARY DRIVEN GEAR
• Install the washer 1 and spacer 2 onto the countershaft.
NOTE:
Apply engine oil to the inside surface of the primary driven gear
bearing.
• Install the primary driven gear assembly 3 and thrust washer
4.
CLUTCH
• Install the clutch sleeve hub 1, lock washer 2 and clutch sleeve
hub nut.
ENGINE 3-57
Tightening Tightening
Direction Direction