Olivetti d-Color MF451 Instructions Manual page 234

9
Message
Incorrect Imaging Unit is in-
stalled. Install the correct Imag-
ing Unit and close all doors.
Set Imaging Unit and shut all
doors
Replenish paper.
Toner (X) is low. Please when in-
dicate.
Install toner cartridge (X)
Toner is depleted
Replace the toner cartridge fol-
lowing the guidance (explana-
tion).
Press the [Continue] button to
continue the operations.
No more staples.
Replace the staple cartridge, or
cancel stapling
Misfeed detected.
Remove misfeed at circle.
Empty hole-punch scrap box
To continue the job, disable
punching.
Reset the following number of
originals.
XX
An internal error occurred. Open
and then close the lower front
door. If the trouble code ap-
pears again, contact your Serv-
ice Rep.
An internal error occurred. Turn
the main switch OFF and ON. If
the trouble code appears again,
contact your Service Rep.
Malfunction detected.
Inform the service representa-
tive of the error code.
Clean the slit scan glass on the
far left with a glass cleaner.
Continuing using the machine in
this condition may cause lines to
appear in the output.
Now Downloading Program
Data from the Firmware server.
9-10
Cause
The correct Imaging Unit is not
set.
The developing unit is not set
correctly.
The indicated tray has run out of
paper.
The toner for the indicated color
is about to run out.
The toner is about to run out.
Toner is depleted
The staples have run out.
Since a paper jam occurred, the
machine is unable to make cop-
ies.
(1) The punch scrap box is full.
(2) The punch scrap box is not in-
stalled.
After clearing a paper jam, it is
necessary to reload certain pag-
es of the original that have al-
ready been fed through the ADF.
The machine malfunctioned and
is unable to make copies.
The machine malfunctioned and
is unable to make copies.
The slit glass is dirty.
(1) CS Remote Care was activat-
ed by your service representa-
tive.
(2) Internet ISW is being down-
loaded.
Troubleshooting table
Remedy
Reinstall each consumable and
replaceable part. Or contact your
service representative.
Reinstall each consumable and
replaceable part. Or contact your
service representative.
Add paper. (p. 8-4)
Prepare to replace the toner car-
tridge following the guidance
contained in your maintenance
agreement.
Replace the toner cartridge fol-
lowing the guidance contained in
your maintenance agreement.
Replace the toner cartridge fol-
lowing the guidance contained in
your maintenance agreement.
Replace the staple cartridge.
Clear the jammed paper.
(1) Throw punch scraps away
from the punch scrap box.
(2) Install the punch scrap box.
Load the indicated original pages
into the ADF.
Take a remedy according to the
message displayed in the
screen. If the problem is not re-
solved or released, inform your
service representative of the
malfunction code displayed in
the screen.
Inform your service representa-
tive of the code displayed in the
screen.
User the slit glass cleaner to
clean it.
Do not turn off the sub power
switch while this message is dis-
played.
After turning off the sub power
switch, turn off the main power
switch, and then contact your
service representative.
d-Color MF651/551/451
9.2