Olivetti d-Color MF451 Instructions Manual page 164

7
Settings
Finisher Adjustment
Density Adjustment
Image Stabilization
Paper Separation Adjust-
ment
Color Registration Adjust
7-12
Punch Horizontal Position Ad-
justment
Punch Regist Loop Size Adjust-
ment
Punch Edge Sensor Adjustment
Vertical Punch (Z-Fold) Position
Adjustment
Horizontal Punch (Z-Fold) Posi-
tion Adjustment
1st Z-Fold Position Adjustment
2nd Z-Fold Position Adjustment
Punch Unit Size Detect Sensor
Post Inserter Tray Size Adjust-
ment
Correct the toner amount to be used by color depending on the paper
type.
• To correct the toner amount to be used in the black print mode, press
[Black Image Density].
Image Stabilization Only
Image Stabilization Setting
Adjust the paper position where the two sides are separated for 2-sided
print.
Correct color shifts if they are detected in the print result.
For details, refer to page 7-23.
System Settings
p. 7-18
p. 7-19
p. 7-19
(This item is displayed when the Fin-
isher FS-526 and Punch Kit PK-516
are installed.)
p. 7-20
(This item is displayed when Z Folding
Unit is installed.)
p. 7-20
(This item is displayed when Z Folding
Unit is installed.)
p. 7-21
(This item is displayed when Z Folding
Unit is installed.)
p. 7-21
(This item is displayed when Z Folding
Unit is installed.)
p. 7-22
(This item is displayed when Z Folding
Unit is installed.)
Adjust the paper size to be used in the
Post Inserter. You can specify differ-
ent paper sizes for the upper and low-
er trays. This button appears when the
Post Inserter PI-505 is installed.
Press the [Start] key to stabilize imag-
es.
Pressing the [Image Stabilization Only]
button executes normal image stabili-
zation.
If a good result was not achieved after
the [Image Stabilization Only] button
was pressed, execute [Initialize + Im-
age Stabilization].
Specify the type and opportunity of
image stabilization. If [Standard] is se-
lected, normal stabilization is per-
formed during warm-up processing
when a change in the absolute humid-
ity has been detected during warm-up
processing.
If [Color Priority] is selected, color sta-
bilization is performed when the pow-
er has been turned on.
Selecting [Black & White Priority] exe-
cutes monochrome stabilization dur-
ing warm-up when absolute humidity
change is detected during the warm-
up, and then stabilizes color before
performing color print.
d-Color MF651/551/451
7.1