Toshiba TECRA A11 Series Maintenance Manual page 383

Installing the LCD unit
To install the LCD unit, follow the steps below and refer to Figure 4-46 to 4-51.
1. Set the brake hinges to the LCD unit and secure them with the following screws.

M2.03C
2. Connect the LCD harness to the connector on the LCD unit and secure it with the
pull tape.
3. Arrange the LCD harness under the guides of the LCD cover.
4. Set the LCD unit on the LCD cover and secure them with the following screws.

M2.55C
NOTE: When securing the LCD unit and LCD cover, be sure to secure the screws in the
order of the number on the Figure 4-49.
5. Set the insulator
NOTE: When sticking the LCD HNS INSULATOR, as shown in the figure below.
6. Set the LCD mask to the LCD assembly while engaging the latches.
NOTE: When setting the LCD mask, be careful not to pinch the cables.
7. Secure the LCD mask with the following screws.

M2.55B
8. Stick the LCD mask cushions in place.
TECRA A11/S11/P11 Satellite Pro S500 Series Maintenance Manual (960-784) [CONFIDENTIAL] 4-93
S-THIN HEAD screw
Tapping screw
(LCD HNS INSULATOR)
FLAT HEAD screw
2
4
under the LCD unit.
2