Toshiba TECRA A11 Series Maintenance Manual page 319

Installing the Optical disk drive
To install the Optical disk drive, follow the steps below and refer to Figure 4-13 to 4-15.
1. When installing a new optical disk drive, set the OD
while securing the latches.
2. Set the ODD rear bracket to the optical disk drive and secure them
following screws.

M2.03C
3. Insert the optical disk drive assembly into the slot to connect it to the connector on
the system board and secure the optical disk drive assem

M2.55B
TECRA A11/S11/P11 Satellite Pro S500 Series Maintenance Manual (960-784) [CONFIDENTIAL] 4-29
Figure 4-15 installing the ODD bezel
BIND screw
FLAT HEAD screw
D bezel to the op tical disk drive
Optical disk drive
ODD bezel
with the
2
bly with the following screw.
1