Toshiba TECRA A11 Series Maintenance Manual page 315

Installing the HDD
To install the HDD, follow the steps below and refer to Figure 4-11 and 4-12.
1. Set the HDD to the HDD Holder and secure them with the following screws.

M3.04C
NOTE: When replacing the HDD holder with a new one, stick the gasket to the HDD
holder in place.
2. Connect the HDD assembly to the connector on the system board. Lay the HDD
assembly down into the slot.
3. Set the HDD cover and secure it with the following screw.

M2.55B
TECRA A11/S11/P11 Satellite Pro S500 Series Maintenance Manual (960-784) [CONFIDENTIAL] 4-25
FLAT HEAD screw
HDD holder
Gasket
FLAT HEAD screw
4
1