Toshiba TECRA A11 Series Maintenance Manual page 356

Installing the RGB harness/ Serial port unit
To install the RGB harness/serial port unit, follow the steps below and refer to Figure 4-36.
1. Connect the serial port FFC to the connector on the serial port unit.
2. Set the serial port unit into the slot of the base assem
following screw.

M2.55B
3. Set the RGB harness into the slot of the base assem
following screw.

M2.55C
NOTE: When replacing the serial port unit with a new one, stick the gaskets and
insulator (UNIT SERIAL INSULATOR) to the serial port unit in place.
4-66 [CONFIDENTIAL] TECRA A11/S11/P11 Satellite Pro S500 Series Maintenance Manual (960-784)
FLAT HEAD screw
Tapping screw
bly and secure it with the
1
bly and secure it with the
1