4.21 RGB harness/Serial port unit
Removing the RGB harness/Serial port unit
To remove the RGB harness/serial port unit, follow the steps below and refer to Figure 4-36.
1. Turn up the insulator (RGB SERIAL INSULATOR).
2. Remove the following screw and take out the RGB harness
assembly.
M2.55C
3. Remove the following screw and take out the serial port unit
base assembly.
M2.55B
4. Disconnect the serial port FFC from the connector on the serial port unit.
4-64 [CONFIDENTIAL] TECRA A11/S11/P11 Satellite Pro S500 Series Maintenance Manual (960-784)
Tapping screw
FLAT HEAD screw
from the slot of the base
1
from the slot of the
1