The Class Setup Screen - ZyXEL Communications P-660HW-Tx v3 User Manual

Chapter 16 Quality of Service (QoS)

16.4 The Class Setup Screen

Use this screen to add, edit or delete classifiers. A classifier groups traffic into data
flows according to specific criteria such as the source address, destination
address, source port number, destination port number or incoming interface. For
example, you can configure a classifier to select traffic from the same protocol
port (such as Telnet) to form a flow.
Click Advanced > QoS > Class Setup to open the following screen.
Figure 103 Advanced > QoS > Class Setup
The following table describes the labels in this screen.
Table 71 Advanced > QoS > Class Setup
LABEL
Create a new
Class
No
Active
Name
Interface
Priority
Filter Content
Modify
Apply
Cancel
260
DESCRIPTION
Click this to create a new classifier.
This is the number of each classifier. The ordering of the classifiers is
important as the classifiers are applied in turn.
Select the check box to enable this classifier.
This is the name of the classifier.
This shows the interface from which traffic of this classifier should
come.
This is the priority assigned to traffic of this classifier.
This shows criteria specified in this classifier.
Click the Edit icon to go to the screen where you can edit the classifier.
Click the Remove icon to delete an existing classifier.
Click this to save your changes.
Click this to restore your previously saved settings.
P-660HW-Tx v3 User's Guide