ZyXEL Communications P-660HW-Tx v3 User Manual page 90

Chapter 5 Internet (WAN) Setup
The following table describes the labels in this screen.
Table 11 Network > Internet (WAN) > Internet Access Setup
LABEL
WAN Type
Type
Line
Modulation
General
Mode
Encapsulation
User Name
Password
90
DESCRIPTION
If you have a DSL modem or router in your network already, you can
set the first Ethernet port as the WAN port and connect it to the DSL
modem or router. This way, you can access the Internet via an
Ethernet connection and still use the QoS, Firewall and VoIP functions
on the ZyXEL Device.
Select ADSL to use the DSL port on the ZyXEL Device.
Select Ethernet(ETH1) to set the first Ethernet port as a WAN port.
The DSL port will then be disabled automatically. This allows the
ZyXEL Device to work as an Ethernet gateway, instead of a DSL
router. To access the Internet, connect the first Ethernet port to a
broadband modem or router.
Note: Only LAN1 port can be used as Ethernet WAN port. Make
sure your device is correctly connected.
Note: The ZyXEL Device restarts after you change the setting in
this field and click Apply.
Select the modulation supported by your ISP.
Use Multi Mode if you are not sure which mode to choose from. The
ZyXEL Device dynamically diagnoses the mode supported by the ISP
and selects the best compatible one for your connection.
Other options are ADSL G.dmt, ADSL2, ADSL2+, ADSL2 AnnexM,
ADSL2+ AnnexM, READSL2 Mode, ANSI T1.413 and ADSL G.lite.
Select Routing (default) from the drop-down list box if your ISP gives
you one IP address only and you want multiple computers to share an
Internet account. Select Bridge when your ISP provides you more
than one IP address and you want the connected computers to get
individual IP address from ISP's DHCP server directly. If you select
Bridge, you cannot use Firewall, DHCP server and NAT on the ZyXEL
Device.
Select the method of encapsulation used by your ISP from the drop-
down list box. Choices vary depending on the mode you select in the
Mode field.
If you select Bridge in the Mode field, select either PPPoA or RFC
1483.
If you select Routing in the Mode field, select PPPoA, RFC 1483,
ENET ENCAP or PPPoE.
(PPPoA and PPPoE encapsulation only) Enter the user name exactly as
your ISP assigned. If assigned a name in the form user@domain
where domain identifies a service name, then enter both components
exactly as given.
(PPPoA and PPPoE encapsulation only) Enter the password associated
with the user name above.
P-660HW-Tx v3 User's Guide