Editing Protocol Filters - ZyXEL Communications P-660HW-Tx v3 User Manual

In the GUI go to Maintenance > Update/Reboot > Configuration. Click the
1
Reset button to clear all user-entered configuration information and return the
ZyXEL Device to its factory defaults.
If you forgot your password or cannot access the web configurator, you will need
2
to use the RESET button at the back of the device to reload the factory default
configuration file. This means that you will lose all configurations that you had
previously and the password will reset to "broadband1".
11.2.1.1 Using the RESET Button
Make sure that the Power LED is on (not blinking).
1
To set the device back to the factory default settings, press the RESET button for
2
5 seconds or until the Power LED begins to blink. Do not turn off the device while
the reset is in progress! When the Power LED stops blinking and lights green, the
defaults have been restored and the device restarts.

11.2.2 Editing Protocol Filters

Use this screen to display a protocol filter set on your ZyXEL Device. Protocol rules
allow you to base the rule on the fields in the IP and the upper layer protocol, for
example, UDP and TCP headers.
In the Packet Filter screen, select Protocol Filter from the Filter Type field.
Then click the Edit button from the Modify field to display the following screen.
Figure 75 Security > Packet Filter > Filter Rules
The following table describes the labels in this screen.
Table 55 Security > Packet Filter > Edit (Protocol Filter)
LABEL
#
Active
P-660HW-Tx v3 User's Guide
DESCRIPTION
This is the index number of the rules in a filter set.
Use the check box to turn a filter rule on or off.
Chapter 11 Packet Filter
213