Static Route Edit - ZyXEL Communications P-660HW-Tx v3 User Manual

Table 65 Advanced > Static Route
LABEL
Apply
Cancel

14.2.1 Static Route Edit

Use this screen to configure the required information for a static route. Select a
static route index number and click Edit. The screen shown next appears.
Figure 92 Advanced > Static Route: Edit
The following table describes the labels in this screen.
Table 66 Advanced > Static Route: Edit
LABEL
Active
Route Name
Destination IP
Address
IP Subnet
Mask
Gateway Type
Gateway IP
Address
P-660HW-Tx v3 User's Guide
DESCRIPTION
Click this to save your changes.
Click this to restore your previously saved settings.
DESCRIPTION
This field allows you to activate/deactivate this static route.
Enter the name of the IP static route. The text may consist of up to 9
letters, numerals and any printable character found on a typical English
language keyboard. Leave this field blank to delete this static route.
This parameter specifies the IP network address of the final destination.
Routing is always based on network number. If you need to specify a
route to a single host, use a subnet mask of 255.255.255.255 in the
subnet mask field to force the network number to be identical to the host
ID.
Enter the IP subnet mask here.
Use either Gateway Address or Gateway Node to configure a static
route.
This field is available when you select Gateway Address from Gateway
Type.
Enter the IP address of the gateway. The gateway is a router or switch on
the same network segment as the device's LAN or WAN port. The
gateway helps forward packets to their destinations.
Chapter 14 Static Route
241