The Packet Filter Screen; Reset To Factory Defaults - ZyXEL Communications P-660HW-Tx v3 User Manual

Chapter 11 Packet Filter

11.2 The Packet Filter Screen

Use this screen to set up packet filters on your ZyXEL Device. Click Security >
Packet Filter to display the following screen.
Figure 74 Security > Packet Filter
The following table describes the labels in this screen.
Table 54 Security > Packet Filter
LABEL
#
Name
Filter Type
Modify
Apply
Cancel

11.2.1 Reset to Factory Defaults

There are two methods of resetting to factory defaults.
212
DESCRIPTION
This field displays the index number of the filter set.
Enter a name for the filter set. The text may consist of up to 16
letters, numerals and any printable character found on a typical
English language keyboard.
Select Protocol Filter or Generic Filter for your filter set.
Protocol filter rules are used to filter IP packets while generic filter
rules allow filtering of non-IP packets.
Click the Edit button to configure a filter set.
Click the Remove button to delete a filter set.
Click this to save your changes.
Click this to restore your previously saved settings.
P-660HW-Tx v3 User's Guide