SMC Networks SMC6624M Management Manual page 366

Switch Memory and Configuration
Overview of Configuration File Management
Rebooting the switch replaces the current running-config file with a new
running-config file that is an exact copy of the current startup-config file.
N o t e
Any of the following actions reboots the switch:
Options for Saving a New Configuration. Making one or more changes
to the running-config file creates a new operating configuration. Saving a new
configuration means to overwrite (replace) the current startup-config file with
the current running-config file. This means that if the switch subsequently
reboots for any reason, it will resume operation using the new configuration
instead of the configuration previously defined in the startup-config file. There
are three ways to save a new configuration:
I
I
I
Note that using the CLI instead of the menu or web browser interface gives
you the option of changing the running configuration without affecting the
startup configuration. This allows you to test the change without making it
"permanent". When you are satisfied that the change is satisfactory, you can
make it permanent by executing the write memory command. For example,
suppose you use the following command to disable port 5:
SMC6624M(config)# interface ethernet 5 disable
The above command disables port 5 in the running-config file, but not in the
startup-config file. Port 5 remains disabled only until the switch reboots. If
you want port 5 to remain disabled through the next reboot, use write memory
to save the current running-config file to the startup-config file in flash
memory.
SMC6624M(config)# write memory
C-2
• Executing the boot or the reload command in the CLI
Executing the Reboot command in the menu interface
•
• Pressing the Reset button on the front of the switch
• Removing, then restoring power to the switch
In the CLI: Use the write memory command. This overwrites the current
startup-config file with the contents of the current running-config file.
In the menu interface: Use the Save command. This overwrites both the
running-config file and the startup-config file with the changes you have
specified in the menu interface screen.
In the web browser interface: Use the [Apply Changes] button or other
appropriate button. This overwrites both the running-config file and the
startup-config file with the changes you have specified in the web browser
interface window.