SMC Networks SMC6624M Management Manual page 92

Configuring IP Addressing, Time Synchronization, Interface Access, and System Information
Time Synchronization Protocol Options
Disabling the SNTP Mode. If you want to prevent SNTP from being used
even if selected by timesync (or the Menu interface's Time Sync Method param-
eter), configure the SNTP mode as disabled.
Syntax:
For example, if the switch is running SNTP in Unicast mode with an SNTP
server at 10.28.227.141 and a server version of 3 (the default), no sntp changes
the SNTP configuration as shown below, and disables time synchronization
on the switch.
SMC6624M(config)# no sntp
SMC6624M(config)# show sntp
Figure 5-10. Example of Disabling Time Synchronization by Disabling the SNTP
Mode
5-24
no sntp
SNTP Configuration
Time Sync Mode: Sntp
SNTP Mode : disabled
Poll Interval (sec) [720] : 720
IP Address Protocol Version
-------------- ----------------
10.28.227.141 3
Disables SNTP by changing the SNTP mode
configuration to Disabled.
Even though the Time Sync Mode is set to
Sntp, time synchronization is disabled
because no sntp has disabled the SNTP
Mode parameter.