SMC Networks SMC6624M Management Manual page 227

For example, if the switch named "DEFAULT_CONFIG" in the above listing
did not have a Manager password and you wanted to make it a stack Member
with an
SMC6624M(config)# stack member 2 mac-address 0060b0-
dfla00
The show stack view command then lists the Member added by the above
command:
SMC6624M(config)# show stack view
Stack Members
SN MAC Address
-- ------------- ---------------- ----------- -------------------------
0
1
2
SN (Switch Number) 2 is the
new Member added by the
stack member command.
Figure 9-30. Example Showing the Stack After Adding a New Member
Using Auto Join on a Candidate. In the default configuration, a Candi-
date's Auto Join parameter is set to "Yes", meaning that it will automatically
join a stack if the stack's Commander detects the Candidate and the Com-
mander's Auto Grab parameter is set to "Yes". You can disable Auto Join on a
Candidate if you want to prevent automatic joining in this case. There is also
the instance where a Candidate's Auto Join is disabled, for example, when a
Commander leaves a stack and its members automatically return to Candidate
status, or if you manually remove a Member from a stack. In this case, you
may want to reset Auto Join to "Yes".
Status:
SMC6624M(config)# no stack auto-join
SMC6624M(config)# stack auto-join
of , you would execute the following command:
SN 2
System Name
0030c1-7fec40 SMC6624M
0060b0-880a80 Indian Ocean
0060b0-df1a00 Big_Waters-2
[no] stack auto-join
Disables Auto Join on a Candidate.
Enables Auto Join on a Candidate.
Configuring Advanced Features
Device Type Status
SMC 10/100 Commander Up
SMC 10/100 Member Up
SMC 10/100 Member Up
The new member did not have a System Name
configured prior to joining the stack, and so receives a
System Name composed of the stack name (assigned in
the Commander) with its SN number as a suffix.
Stack Management
9-37