Configuring For Snmp Access To The Switch - SMC Networks SMC6624M Management Manual

The switch SNMP agent also uses certain variables that are included in an
SMC proprietary MIB file you can add to the SNMP database in your
network management tool.
Configuring for SNMP Access to the
Switch
SNMP access requires an IP address and subnet mask configured on the
switch. (See "IP Configuration" on page 5-2.) If you are using DHCP/Bootp to
configure the switch, ensure that the DHCP/Bootp process provides the IP
address. (See "DHCP/Bootp Operation" on page 5-9.)
Once an IP address has been configured, the general steps to configuring for
SNMP access to the preceding features are:
1. From the Main menu, select
2. Switch Configuration . . .
6. SNMP Community Names
2. Configure the appropriate SNMP communities. (The "public" community
exists by default and is used by network management applications.) (For
more on configuring SNMP communities, see "Menu: Viewing and Config-
uring SNMP Communities" on page 8-5.)
3. Configure the appropriate trap receivers. (For more on configuring trap
receivers, see "CLI: Configuring and Displaying Trap Receivers" on page
8-10.)
In some networks, authorized IP manager addresses are not used. In this case,
all management stations using the correct community name may access the
switch with the View and Access levels that have been set for that community.
If you want to restrict access to one or more specific nodes, you can use the
switch's IP Authorized Manager feature. (See "Using IP Authorized Managers"
on page 7-28.)
Configuring for Network Management Applications

Configuring for SNMP Access to the Switch

8-3