SMC Networks SMC6624M Management Manual page 99

Configuring IP Addressing, Time Synchronization, Interface Access, and System Information
For example, suppose TimeP is running as the switch's time synchronization
protocol, with DHCP as the TimeP mode, and the factory-default polling
interval. You would halt time synchronization with this command:
SMC6624M(config)# no timesync
If you then viewed the TimeP configuration, you would see the following:
SMC6624M(config)# show timep
Timep Configuration
Time Sync Mode: Disabled
TimeP Mode : DHCP
Poll Interval (min) : 720
Figure 5-16. Example of TimeP with Time Sychronization Disabled
Disabling the TimeP Mode. Disabling the TimeP mode means to configure
it as disabled. (Disabling TimeP prevents the switch from using it as the time
synchronization protocol, even if it is the selected Time Sync Method option.)
no ip timep
Syntax:
For example, if the switch is running TimeP in DHCP mode, no ip timep changes
the TimeP configuration as shown below, and disables time synchronization
on the switch.
SMC6624M(config)# no ip timep
SMC6624M(config)# show timep
Timep Configuration
Time Sync Mode: Timep
TimeP Mode : Disabled
Figure 5-17. Example of Disabling Time Synchronization by Disabling the TimeP
Mode Parameter
Time Synchronization Protocol Options
Server Address :
Disables TimeP by changing the TimeP mode
configuration to Disabled.
Even though the Time Sync Mode is set to Timep,
time synchronization is disabled because no ip
timep has disabled the TimeP Mode parameter.
5-31