SMC Networks SMC6624M Management Manual page 229

Syntax:
stack member <switch-number>
mac-address <mac-addr>
[password<password-str>]
In the destination Commander, use show stack all to find the MAC address of
the Member you want to pull into the destination stack. For example, suppose
you created a new Commander with a stack name of "Cold_Waters" and you
wanted to move a switch named "Bering Sea" into the new stack:
SMC6624M(config)# show stack all
Stacking - Stacking Status (All)
Stack Name MAC Address
--------------- ------------- ------------------------- --------------------
Big_Waters 0030c1-7fec40 SMC6624M
0060b0-880a80 Indian Ocean
0060b0-df1a00 Bering Sea
Cold_Waters 0030c1-7fc700 Cold_waters-0
Figure 9-32. Example of Stack Listing with Two Stacks in the Subnet
You would then execute the following command to pull the desired switch
into the new stack:
SMC6624M(config)# stack member 1 mac-address 0060b0-
df1a00
Where is an unused switch number (
1
Since a password is not set on the Candidate, a password is not needed in this
example.
You could then use
Using a Member CLI To "Push" the Member into Another Stack. You
can use the Member's CLI to "push" an SMC6624M stack Member into a
destination stack if you know the MAC address of the destination Commander.
Syntax: stack join <mac-addr>
where: <mac-addr> is the MAC address of the Commander for the desti-
nation stack.
Converting a Commander to a Member of Another Stack. Removing
the Commander from a stack eliminates the stack and returns its Members to
the Candidate pool with
System Name
Move this switch into the "Cold Waters" stack.
SN
again to verify that the move took place.
show stack all
disabled.
Auto Join
Configuring Advanced Features
Stack Management
Status
Commander Up
Member Up
Member Up
Commander Up
).
9-39