Cli: Modifying The Interface Access - SMC Networks SMC6624M Management Manual

Configuring IP Addressing, Time Synchronization, Interface Access, and System Information

CLI: Modifying the Interface Access

Interface Access Commands Used in This Section
show console
[no] telnet-server
[no] web-management
console
Listing the Current Console/Serial Link Configuration. This com-
mand lists the current interface access parameter settings.
Syntax:
This example shows the switch's default console/serial configuration.
SMC6624M# show console
Console/Serial Link
Interface Access
Enable/Disable
Inbound Telnet Enabled : Yes
Web Agent Enabled : Yes
Terminal Type : VT100
Screen Refresh Interval (sec) : 3
Displayed Events : All
Baud Rate : speed-sense
Console Control
Flow Control : XON/XOFF
Options
Session Inactivity Time (min) : 0
Figure 5-20. Listing of Show Console Command
Reconfigure Inbound Telnet Access. In the default configuration,
inbound Telnet access is enabled.
Syntax:[no] telnet-server
To disable inbound Telnet access:
SMC6624M(config)# no telnet-server
To re-enable inbound Telnet access:
SMC6624M(config)# telnet-server
Interface Access: Console/Serial Link, Web, and Inbound Telnet
below
below
page 5-38
page 5-38
show console
Event Log Event
Types To List
5-37