SMC Networks SMC6624M Management Manual page 118

Optimizing Port Usage Through Traffic Control and Port Trunking
Viewing Port Status and Configuring Port Parameters
Syntax:
The next two figures list examples of the output of the above two commands
for the same port configuration on the SMC6624M.
SMC6624M> show interfaces
Figure 6-1. Example of a Show Interface Command Listing
SMC6624M> show interface config
Figure 6-2. Example of a Show Interface Config Command Listing
Using the CLI To Configure Ports. You can configure one or more of the
following port parameters. For details on each option, see Table 6-1 on page
6-2.
Syntax:
6-6
show interfaces
show interface config
Status and Counters - Port Status
| Intrusion
Port Type | Alert
---- --------- + --------- ------- ------ ---------- --------- ------
1 10/100TX | No
2 10/100TX | No
3 10/100TX | No
4 10/100TX | No
5 10/100TX | No
6 10/100TX | No
7 10/100TX | No
8 10/100TX | No
9 10/100TX | No
10 10/100TX | No
Port Settings
Port Type | Enabled Mode
---- --------- + ------- ------------ ---------
1 10/100TX | Yes
2 10/100TX | Yes
3 10/100TX | Yes
4 10/100TX | Yes
5 10/100TX | Yes
6 10/100TX | Yes
7 10/100TX | Yes
8 10/100TX | Yes
9 10/100TX | Yes
10 10/100TX | Yes
[no] interface <[ethernet] port-list>
[disable | enable]
[speed-duplex
<auto-10 |10-full | 10-half | 100-full | 100-half |auto|1000-full |>]
[flow-control]
[broadcast-limit <0 - 99>]
Enabled Status Mode
Yes Down 10HDx
Yes Down 10HDx
Yes Down 10HDx
Yes Down 10HDx
Yes Down 10HDx
Yes Down 10HDx
Yes Down 10HDx
Yes Down 10HDx
Yes Down 10HDx
Yes Down 10HDx
Flow Ctrl
Auto Disable
Auto Disable
Auto Disable
Auto Disable
Auto Disable
Auto Disable
Auto Disable
Auto Disable
Auto Disable
Auto Disable
Flow Bcast
Ctrl Limit
off 0
off 0
off 0
off 0
off 0
off 0
off 0
off 0
off 0
off 0