Program Change Table Edit; Exclusive Message (Device Number); Exclusive Message (Bulk Dump) - Yamaha V50 Authorized Product Manual

This function allows you to initialize the program
change table to the following condition.
When you press
sure?". Press again, and the program change
table will be initialized.

Program change table edit

Press press the
below " > Edit" to get the following
press the
display.
You can press the
the previous display.
Function
Edit the program change table.
Explanation
The program change number is displayed on the left
of the " = " , and on the right side, the V50 voice or
performance number is displayed.
Press the below the up/down arrows in the
display to select the program change number (dis-
played at left), and specify the voice number which
it will select (displayed at right). Use
or
preset voices. To select performances, press
while pressing
or
In this way, set a voice or performance to be
selected by each incoming program change.
Pressing "Inc" after memory 99 will advance to
the next memory.
Program change transmit
This is not actually a utility function, but we will explain
it here. This allows you to transmit a program change
message from MIDI OUT without affecting the V50.
When in performance play mode or single play
mode, press and hold
and the display will show "Sending Pc
you will be asked "Are you
below " > PgmCng", and
below " > EXIT" to return to
to select internal, card, or
No.---". Continuing to press the key, use the
keys to enter a three-digit (001 – 128)
program change number. The specified program change
will be sent on the specified transmit channel at the in-
stant you release

Exclusive message (device number)

Press
to get the following display.
You can press the
the previous display.
Function
Set the MIDI channel on which to receive and transmit
system exclusive messages.
Settings
off, 1 – 16, all
Explanation
This sets the MIDI channel on which system exclusive
messages (data for voices and performances, etc.)
will be transmitted and received. Select one of the
following.
off Exclusive messages will not be transmitted.
1 – 16 Exclusive messages will be transmitted on the
channel specified here. (The next section ex-
plains the actual transmission.)
all Exclusive messages of any channel will be
received. Channel 1 will be used for trans-
mission.
,
Note:
When this "off", exclusive messages will not be
transmitted, and when a V50 voice is selected, a
program change message will be transmitted.
The device receiving the exclusive message must
be set to match the channel specified here.

Exclusive message (bulk dump)

Press press the
press the
display.
or
or
and press the below " > Exclusive"
below " > EXIT" to return to
below " > Exclusive", and
below " > BULK" to get the following
Utility functions 103