Setup Functions; Master Tuning, Synthesizer Volume; Combine; Controller Reset - Yamaha V50 Authorized Product Manual

Master tuning, synthesizer volume

Press then press the
to get the following display.
You can press the
the previous display.
(1) Master tuning
Function
Set master tuning.
Settings
–64 – +64
Explanation
Master tuning affects the entire V50 in both per-
formance play mode and single play mode. In per-
formance play mode this will adjust the overall tuning
of all instruments.
The setting can be adjusted over a range of ap-
proximately one half step up or down. At a setting
of 0, A3 will be 440.0Hz. A setting of - 64 is - 100
cents (one half step down), and a setting of +64 is
98.4 cents (approximately one half step up).
This function allows you to tune the V50 to in-
struments that are not tuned to A3 = 440Hz.
(2) Synthesizer volume
Function
Set the synthesizer volume.
Settings
0 – 99
Explanation
This is used to adjust the volume balance between
the synthesizer section and the rhythm machine. 0 is
minimum volume, and 99 is maximum volume.
Note:
At a setting of 0, you will not be able to hear the
synthesizer.
110 Utility functions

SETUP FUNCTIONS

below " > Tune"
below " > EXIT" to return to

Combine

Press then press the
to get the following display.
You can press the
the previous display.
Function
Disconnect function data from a voice.
Settings
off, on
Explanation
Each voice data setting is actually divided into two
types of data; voice data and function data. The voice
data determines the sound of the voice, and the
function data determines how the voice is controlled.
This combine function disconnects the function data
from the rest of the voice data.
When function data is disconnected, selecting a
different voice will change only the voice data, pre-
serving the previous function data. This allows you
to change only the voice while preserving the settings
(modulation wheel, aftertouch, foot controller, effect
etc.) that determine how it is controlled.
"on" is the usual setting, when function data is
not disconnected. When set to "off", function data
is disconnected.
This setting also applies to performance mode,
and the voice function data and effect data will be
preserved even when a different performance is se-
lected. If you set combine "off" and select a different
voice or performance, the first character of the voice
or performance name will be displayed in lower case
to indicate that the function settings of the previously
selected voice are being used.

Controller reset

Press then press the
get the following display.
You can press the
the previous display.
below " > Comb"
below " > EXIT" to return to
below " > Ctrl" to
below " > EXIT" to return to