Yamaha V50 Authorized Product Manual page 134

2. MIDI transmission condition
3. Channel message
3.1 Transmission
3.1.1 Note on/off
Transmitted note range = C1 (36) – C6 (96)
Velocity range = 0 – 127 (0: note off)
3.1.2 Control change
When the following controllers are moved, MIDI is transmitted.
*1
The control change switch cannot turn transmission on/off.
In system setup mode, the transmission mode can be selected.
off : No control changes are transmitted.
: Transmitted on the channel specified by Trns.ch
norm/G1–G16
3.1.3 Program change
When a voice is selected in single mode, or when a performance is
selected in performance mode, a program change is transmitted. Re-
gardless of the mode, the program change number is assigned as follows.
I, P, C, PFI, PFC, PFP
00–99
Transmission can be turned on/off by mode.
1) off:
program changes are not transmitted
2) common/individual/direct:
Transmitted when voice/performance is selected in SYNTH mode.
However, program changes transmitted from the internal sequencer
for data created on the V50 consist of bytes, and are transmitted
as follows.
See the reception section for the meaning of mode (IND/SGL/PFM).
3) Transfilter:
Transmit on the channel specified by Trans ch. However program
changes from the internal sequencer will be transmitted as a single
byte without program changes above 119 (for SEQ mode). (For tone
generators other than the V50.)
3.1.4 Pitch bend
Pitch bend is transmitted with 7 bit resolution.
Transmission on/off is possible in system setup (off, norm,
G1 – G16). The contents are, the same as for control change.)
3.1.5 Aftertouch
Transmission on/off is possible in system setup (off, norm,
G1 – G16). The contents are the same as for control change.)
3.1.6 Channel mode messages
The following messages are transmitted when the mono/poly mode
of a voice is changed.
MONO mode ($Bn, $7E, $01) only in single mode
POLY mode ($Bn, $7F, $00) only in single mode
3.2 Reception
3.2.1 Note on/off
Note reception range = C-2 – G8
= 0 – 127 (only note on)
Velocity range
In system setup, the following settings are possible.
normal = all note numbers are received
odd = only odd note numbers are received
even = only even note numbers are received
3.2.2 Control change
The following parameters can be controlled via MIDI.
Program change no.
00–99
129