Yamaha V50 Authorized Product Manual page 39

bf ft10m Settings for 14:DelayL/R & Rev.
Parameter
Settings
RevTime 0.3 sec.–10.0 sec
Lch Dly 0 ms.–300 ms
Rch Dly 0 ms.–300 ms
Settings for 21: Tunnel
Parameter
Settings
RevTime 0.3 ms–10.0 ms
Delay 0.1 ms–300 ms
FB Gain 0%–99%
Settings for 22: Doubler 1
Parameter
Settings
DlyTime
0.1 ms–50 ms
HPF
160 Hz–
1000 Hz, thru
LPF 1.25KHz–12.0KHz
34
Performance Edit
Comment
Specify the time it takes for the
reverb to decay. Long settings
(long reverb times) cause a
slower decay.
Specify the delay time for the left
channel. As this setting is in-
creased, there will be a longer
wait until the first delayed sound
appears from the left channel.
Specify the delay time for the
right channel. As this setting is
increased, there will be a longer
wait until the first delayed sound
appears from the right channel.
Comment
Specify the time it takes for the
reverb to decay. Long settings
(long reverb times) cause a
slower decay.
Specify the delay time. As this
setting is increased, there will
be a longer wait before the de-
layed sound appears.
Specify the amount of delay
feedback. As this setting is in-
creased, there will be more delay
repeats.
Comment
Specify the time until the delayed
sound. As this setting is in-
creased, there will be a longer
wait before the delayed sound
appears.
Specify the high pass filter set-
ting. Frequencies below the
specified frequency will be cut.
Specify the low pass filter setting.
Frequencies above the specified
frequency will be cut.
Settings for 23: Doubler 2
Parameter Settings
Lch Dly 0.1 ms–50 ms
Rch Dly 0.1 ms–50 ms
LPF 1.25KHz–12.0KHz
Settings for 24: Feed Back Gate, 25: F. Back Reverse, 26: Feed
Back E/R
Settings
Parameter
0.5–3.2
Size
LPF 1.25KHz–12.0KHz
FB Gain 0%–99%
Settings for 27: Delay & Tone1, 28: Dly L/R & Tone1, 30:
Delay & Tone2, 31: Dly L/R & Tone2
Parameter Settings
Bril 0–12
Delay 0.1 ms–300 ms
FB Gain 0%-99%
Comment
Specify the delay time for the left
channel. As this setting is in-
creased, there will be a longer
wait before before the delayed
sound appears from the left
channel.
Specify the delay time for the
right channel. As this setting is
increased, there will be a longer
wait before before the delayed
sound appears from the right
channel.
Specify the low pass filter setting.
Frequencies above the specified
frequency will be cut.
Comment
Specify the size of a hypothetical
room. Larger settings will cause
a more spacious effect.
Specify the low pass filter setting.
Frequencies above the specified
frequency will be cut.
Specify the amount of delay
feedback. As this setting is in-
creased, there will be more delay
repeats.
Comment
Specify the brightness of the
sound. Larger settings will result
in a brighter sound.
Specify the delay time. As this
setting is increased, there will
be a longer wait before the de-
layed sound appears.
Specify the amount of delay
feedback. As this setting is in-
creased, there will be more delay
repeats. For a setting of 0%. there
will be no second or subsequent
delay sound.