Step Recording Procedure; Select The Sequencer Function; Select A Song To Record; Select Step Recording - Yamaha V50 Authorized Product Manual
Yamaha v50 digital synthesizer operating manual
Hide thumbs
Also See for V50:
- Owner's manual (109 pages) ,
- Operating manual (82 pages) ,
- Use manual (78 pages)
Table of Contents
Advertisement
The procedure for step recording is as follows.
Select the sequencer function
From performance play mode, single play mode, or
rhythm mode, enter the sequencer mode as follows.
(1) Press
to enter sequencer mode and get the
following display.
All sequencer operations are carried out in this mode.
Select a song to record
Select the number of the song to be recorded.
(1) Move the cursor to the far left, and specify a song
1 - 8 to record. If setup data has already been stored
for the song, the display will show "withPFM" or
"Song only" when you select the song. (This choice
is explained on page 87.)
Select step recording
Here we will explain the most basic way to select step
recording. For details, see page 94.
(1) Press
to get the following display.
84
Using the sequencer
STEP RECORDING PROCEDURE
Begin sequencer operations.
Select the song you want to record.
Select step recording.
Select the track to be recorded, the voices and
time signature, tempo, etc.
Start and end step recording.
(2) Press the
below " > Rec" to get the following
display.
(3) Making sure that the cursor is located at " > Mode",
select the recording mode. Select from "Realtime",
"Step", or "Punch". In this example we will select
"Step".
(4) Press the
below " > EXIT" twice.
Note:
In step recording, "Overdub" will always be used
regardless of the " > Condition" setting.
Set recording conditions
This is where you select the song and tracks to be re-
corded, and set time signature, tempo, rhythm backing,
and the performance or voice to be used. However if
no data exists, you will not be able to advance the
measure.
Note:
You cannot change the time signature of a track that
has already been recorded. When you want to begin
recording from the middle of the song, use
to change the measure, or move the cursor to
" > Meas" and directly specify the measure.
(1) Press
to enter recording mode and get the
following display.
and
Advertisement
Table of Contents
