Punch-In Recording; Setup Functions - Yamaha V50 Authorized Product Manual

Punch-in recording allows you to re-record only a spe-
cified measure or measures using realtime recording,
using the following procedure.
to get the following display.
(1) Press
(2) Press the below " > Rec" to get the following
display.
(3) Make sure that the cursor is located at " > Mode",
and change the recording mode to "Punch". In
punch-in recording, "Replace" will always be used
regardless of the " > Condition" setting.
These functions determine the receive channel and var-
ious other aspects of the sequencer. In sequencer mode,
press to get the following display.
Press the below "> Setup" to get the following
display.
If you press the below " > EXIT" you will return
to the previous display.
(1) Receive channel
Function
Set the receive channel of the sequencer.
88 Using the sequencer

PUNCH-IN RECORDING

(4) Press
(5) Specify the measure from which to start playback
(6) Press
(7) Press

SETUP FUNCTIONS

to get the following display.
(Meas), and the beginning (In) and end (Out) of the
measures to be re- recorded. Make sure that "Meas"
"In" "Out".
to select the track to punch-in.
. Playback will begin from the measure
you specified in "Meas". When the measure "In"
is reached, recording will automatically begin.
Play the keyboard to re-record the specified
section.
When the measure "Out" is reached, recording
will automatically end. This completes punch-in
recording.
Settings
Kbd, 1 – 16, om
Explanation
This determines the MIDI channel that the sequencer
will receive. Select from the following.
Kbd......Record from the V50 keyboard. MIDI
messages from external devices will not be
recorded.
1 – 16... Record incoming MIDI messages of the
specified channel. When recording MIDI
messages from an external device, set this to
match the transmit channel of the external
device.
omn. . . . . Record incoming MIDI messages of any
channel.
Note:
Unless
this "receive channel" is set to "kbd", your
playing on the V50 keyboard will not be recorded.