Send Bank Select And Program Change - Yamaha SY99 Owner's Manual

VOICE PLAY MODE
Pitch Bend Wheel Range: This displays the
range over which the PITCH wheel can raise or
lower the pitch.
After Touch: This area displays the zoned after-
touch mode, the split point, and the aftertouch
pitch bend setting.
The bottom line displays the two effect parame-
ters which have been selected for realtime con-
trol, and the controller which is affecting each
effect parameter.
Controller abbreviations: The following abbrevia-
tions will be displayed to indicated commonly-
used control sources
MW1 Modulation Wheel
MW2 Assignable Modulation Wheel
Summary: While in voice play mode you can
transmit bank select and program change mes-
sages from MIDI OUT without affecting the
SY99's own tone generator. This allows you to
switch a tone generator module connected to the
SY99 MIDI OUT to another memory without
changing the SY99's own memory selection.
(An identical function is available in multi play
mode.)
Procedure:
From: voice play mode
Select: F1 (Send)
Specify: a bank select number (1-16,384) and
a program change number (1-128).
To transmit: the bank select and program change
messages press ENTER.
To quit: without sending a bank select or pro-
gram change message, press EXIT.
1. Use the numeric key pad to enter a number be-
tween 1 and 16,384, then press ENTER to move
the cursor to the program change item. (To send
a program change message but no bank select
message, simply press ENTER.)
2. Use the numeric keypad to enter a number be-
tween 1 and 128.
88

Send bank select and program change

(JUMP #100)
BC Breath Controller
VOL Volume
Foot Controller
FC
Data Entry Slider
DE
Sustain Switch
SUS
FS Assignable Foot Switch
AFT Aftertouch
VEL Velocity
SCL Scaling
LFO Effect LFO
This function only allows you to view the controller
assignments. To edit them, refer to Voice Common
job 12. Controller, and Voice Common job 10.5 Effect
control.
3. Press ENTER and the specified bank select and
program change messages will be transmitted
on the keyboard transmit channel (Kyb Trans
Ch) specified in MIDI Utility job 1. Setting (JUMP
#807).
If, for the program change, you enter a number
below 1 it will be transmitted as 1. If you enter a
number above 128, it will be transmitted as 128.
In addition to the program change message
transmitted by this function, a program change
message will be transmitted every time you
select a SY99 voice or multi unless Program
Change has been turned off using MIDI utility
job 1.Setting, page 258.
Remark: Refer to the MIDI Data Format booklet
for details regarding the use of MIDI bank select
numbers.
Note: If a master control setup is activated, the
transmit filter for that setup may prevent the
sending of bank select and program change mes-
sages using this function. Refer to the explana-
tion of the Master control utility on page 284 for
further details.