Erase; Remove - Yamaha V50 Authorized Product Manual

If you specify "Tr1 002 - 003 to Tr1 006" as shown
in the upper diagram, the song will change as shown
in the lower diagram. (The measures will be renum-
bered as "1, 2, 3,...")
After specifying the track, and beginning and end
measures of the source, and the track and measure
of the destination, press the
Press in reply to the confirming message, and
the measures will be copied.
Press the below " > Erase".
Function
Erase the data in the specified range of measures.
Explanation
The data in the specified range of measures will be
erased, and replaced with rests. This allows you to
erase part of a single track, or part of all tracks (when
"all" is selected instead of a track number).
If you specify "Tr1 from 002 to 003" as shown in the
upper diagram, the song will change as shown in the
lower diagram.
After specifying the track, and beginning and end
measures, press the
+ in reply to the confirming message, and the
measures will be
erased.
below " > GO".

Erase

below " > GO". Press

Remove

Press the below " > Remov".
Function
Remove the specified data from the specified meas-
ures.
Explanation
This removes pitch bend wheel data, aftertouch data,
or other control change data from the specified range
of measures. The note data will remain.
Select one of the types of data to be removed.
Cnt . . . . . .
Remove control change data. When this is
selected, you will also be able to specify the
range of control change numbers 0 – 127 to
be removed.
P.B. . . . . . Remove pitch bend wheel data.
A.T. . . . . . Remove aftertouch data.
After specifying the track and type of data to be re-
moved (and when "Cnt" is selected, the range of
control numbers), the track, and beginning and end
measures, press the
in reply to the confirming message, and the
specified data will be removed.
below " > GO". Press
Using the sequencer 93