How To Access The Target Component - Brother DCP375CW Service Manual

Removing the handset mount*
Handset mount*
Pull the tab on the bottom of the
handset mount outwards, and
remove the handset mount in the
direction of the arrow.
(5) Remove all four ink cartridges and set the protective part instead. Check that the small tabs
on both sides of the protective part fit in the holes provided in the ink refill ASSY.
Protective part

How to Access the Target Component

• On the next page is a disassembly flowchart which helps you access the target components.
To remove the maintenance unit, first find it on the flowchart and note its section number
(Section 6.1.15 in this case). To access it, you need to remove all the parts above the
maintenance unit on the flowchart
before the unit itself can be removed.
• Unless otherwise specified, all parts should be replaced in the opposite order to which they
were removed to reassemble the machine.
Installing the handset mount*
Align the
machine and handset mount with
each other and slide the handset
mount in the direction of the arrow.
(Sections 6.1.1, 6.1.2, 6.1.5, 6.1.7, and
6-4
markings on the
(Handset_mount)
* For models with handset
(Protective_part_mini9)
6.1.14 in this case)
Confidential