If You Replace The Head/Carriage Unit Or Engine Unit; 1 ] Update The Head Property Code Stored In The Eeprom On The Main Pcb - Brother DCP375CW Service Manual

7.2

IF YOU REPLACE THE HEAD/CARRIAGE UNIT OR ENGINE UNIT

[ 1 ] Update the head property code stored in the EEPROM on the main PCB

(1) Make sure that the machine's power cord is unplugged from an electrical outlet.
If the machine is connected to a PC, unplug the USB cable.
(2) Switch on the PC.
(3) Plug the machine's power cord into an electrical outlet.
(4) Switch the machine to the maintenance mode using the steps below. (Refer to
Models without touch panel
Press the Menu and Black Start (Mono Start) keys in this order. Next press the
four times.
Models with touch panel
Press the Menu key on the touch panel and the Black Start (Mono Start) key on the
control panel. Next press the Scan key four times.
TIP: When the touch panel is inoperable, simultaneously press the Scan and Copy keys on
the control panel, instead of the Menu key, and press the Black Start (Mono Start) key.
Next press the Scan key four times.
TIP: Models equipped with a numerical keypad on the control panel can enter the
maintenance mode in the same way as conventional models; that is, by pressing the Menu,
*, 2, 8, 6 and 4 keys in this sequence.
The machine
"
the maintenance mode, a mode in which the machine is ready to accept entry from the keys.
(5) Connect the machine to the PC using a USB cable.
beeps for approx.
" on the LCD, indicating that it is placed in the initial stage of
7-7
one second (MFC
Chapter 9.)
key
only) and displays
Confidential