If You Replace The Ink Absorber Box Or Flushing Box; 1 ] Reset Each Of The Purge And Flushing Counters - Brother DCP375CW Service Manual

7.5

IF YOU REPLACE THE INK ABSORBER BOX OR FLUSHING BOX

When either the ink absorber box or flushing box is replaced, you should replace both of them.

[ 1 ] Reset each of the purge and flushing counters

(1) Switch the machine to the maintenance mode using the steps below. (Refer to
Models without touch panel
Press the Menu and Black Start (Mono Start) keys in this order. Next press the
four times.
Models with touch panel
Press the Menu key on the touch panel and the Black Start (Mono Start) key on the
control panel. Next press the Scan key four times.
TIP: When the touch panel is inoperable, simultaneously press the Scan and Copy keys on
the control panel, instead of the Menu key, and press the Black Start (Mono Start) key.
Next press the Scan key four times.
TIP: Models equipped with a numerical keypad on the control panel can enter the
maintenance mode in the same way as conventional models; that is, by pressing the Menu,
*, 2, 8, 6 and 4 keys in this sequence.
The machine
"
the maintenance mode, a mode in which the machine is ready to accept entry from the keys.
(2) Press the 8 and 0 keys in this order in the initial stage of the maintenance mode. (For
models without numerical keypad, enter 8 and 0 using the
(3) Press the Black Start (Mono Start) key several times until the purge (or flushing) count
appears on the LCD.
(4) Press the 2, 7, 8, and 3 keys in this order to reset the purge (or flushing) count. (For models
without numerical keypad, enter 2, 7, 8, and 3 in this order using the
(5) Press the Stop/Exit key to return to the initial stage of the maintenance mode.
(6) Press the 9 key twice to exit from the maintenance mode. (For models without numerical
keypad, enter 9 twice using the
Tip: This machine counts all purge operations and flushing operations performed since
produced in order to prevent the ink absorber box and flushing box from overflowing with
drained and flushed ink, respectively. An initial purge, for example, advances the counter by
133 + 316 = 449.
When the purge or flushing counter approaches 5760 or 568181818, respectively, the
"MACHINE ERROR 46" appears, and further purge or flushing operations are prohibited.
Replace the ink absorber box and flushing box, and then reset their counters.
beeps for approx.
" on the LCD, indicating that it is placed in the initial stage of
, and OK keys.)
7-39
one second (MFC
,
Chapter
only) and displays
and OK keys.)
, and OK keys.)
Confidential
9.)
key