Control Panel Assy - Brother DCP375CW Service Manual

6.1.5

Control Panel ASSY

(1) Remove three screws from the control panel ASSY.
(2) Pull up the rear end of the control panel ASSY and turn it up slightly.
NOTE: Do not pull the control panel ASSY away from the machine since it is connected to
the machine with a short LCD flat cable
(3) While holding the control panel ASSY at an angle of approx. 45°, disconnect the panel-
main harness, touch panel harness
main PCB.
NOTE: After disconnecting the flat cable(s), check that each cable is not damaged at its
end or short-circuited. When connecting the flat cable(s), do not insert it at an angle. After
insertion, check again that it is not at an angle.
Panel-main harness
Touch panel harness
Upper cover
"a"
2
*
Main PCB
Connector for
*
touch panel harness
*1
and harnesse(s).
*2
, grounding wire
Control panel ASSY
"a"
2
"a": Taptite, bind B M3x10
"b": Taptite, cup S M3x6
6-27
*1 For models with color LCD
*2 For models with touch panel
*2
, and LCD flat cable
"a"
LCD flat cable
Grounding wire
"b" 2
*
Connector for
LCD flat cable
Connector for
panel-main harness
*1
from the
1
*
2
*
1
*
(6_33)
Confidential