To Load Programs Using An External Memory - Brother DCP375CW Service Manual

(3) On the machine, display the version of the firmware installed on the LCD using the
following steps to check it.
Models with numerical keypad on the control panel
Simultaneously press the * and # keys.
Models without numerical keypad on the control panel
Simultaneously press the
- Sample version number shown on the monochrome LCD: A0307252244:CF30
- Sample version number shown on the color LCD:
(The top line shows the version number.)
If the displayed version number is identical with the firmware version you installed,
the loading operation has been successfully finished.
Note: If loading operation ends abnormally, turn the machine off and on. Wait for the
machine to emit a long beep (MFC only) and automatically enter the firmware loading
mode, and then perform the loading procedure above again.

To load programs using an external memory

Refer to Chapter 9, Section
Note: If program loading with an external memory fails, load programs from the PC
following the instructions given on
and Stop/Exit keys.
9.4.8.
page App. 2-7.
App. 2-8
0A630619103:FE46
P0601242005:4123
B0601242005:1C8D
Confidential