Replacing P_Rear Sensor Assembly - Xerox 7142 Service Manual

RJ-901C/RJ-900C Maintenance Manual
4.9.2

Replacing P_REAR Sensor Assembly

NOTE
Before replacing parts in the P_REAR sensor assembly, remove the following covers.
• Rear cover:
1. Remove the PF_REAR sensor assembly connector from the main board assembly.
2. Take the P_REAR sensor assembly cable off the clamp.
3. Remove the screw retaining the PE sensor plate to the frame (tapping screw M3
1
4. Remove the screw retaining the P_REAR sensor assembly to the PE sensor plate (cup screw M2
2pce).
5. Replace the P_REAR sensor assembly.
"4.2.7 Removing Media Guide R2" p.4-14
1
No.
1 P_REAR sensor assembly
2 PE sensor plate screw
3 PE sensor plate
No.
1 P_REAR sensor assembly
screw
2 P_REAR sensor assembly
3 PE sensor plate
4-63
4 Parts Replacement
×
6, S tight cup: 1pce).
Part name
×
6:
Part name