4 Parts Replacement
2. Pull out the CR_HP cable assembly connector from the CR_HP sensor.
1
3. Release the hook retaining the CR_HP sensor, then remove the CR_HP sensor.
4. Replace the CR_HP sensor.
5. To reassemble the unit, reverse the removal procedure.
6. Perform adjustments by following the instructions in
4.5.3
Replacing Lever Sensor
NOTE
Before replacing the lever sensor, remove the following covers.
• R side cover:
1. Move down the pressure lever forward (downward).
"4.2.1 Removing R Side Cover" p.4-6
RJ-901C/RJ-900C Maintenance Manual
No.
1
2
3
2
"7.2 Adjustment Item"
4-32
Part name
Hook
CR_HP sensor
Connector
p.7-3.