Pg Height Adjustment; Jigs And Tools; Adjustment Procedure - Xerox 7142 Service Manual

7 Adjustment

7.10 PG Height Adjustment

This section describes the procedure to check the carriage height (distance from the platen).

7.10.1 Jigs and Tools

The following jigs and tools are required for carriage height (distance from the platen) check.
• PG height checking step gauge
TIP
"10.4 Jigs and Tools" p.10-7

7.10.2 Adjustment Procedure

Follow the steps below to adjust the platen height.
1. When moving the carriage, place the PG height checking jig on the second platen from the origin.
2. Move the carriage from the origin side while the lever is in "LOW".
RJ-901C/RJ-900C Maintenance Manual
No.
1
Step Gauge JD-42177
Platen
2
7-32
Part name