Xerox 7142 Service Manual page 182

5 Self-Diagnosis Mode
5.9.3 Cutter Endurance Menu
In this endurance menu, media can be cut according to the value set.
You can cut the media according to your desired settings.
CAUTION
When performing cutter endurance, note the following;
• Install available ink cartridges.
• Confirm that media initialization has completed.
If performing cutter endurance operation without ink cartridge, Ink in the ink tube may leak
out from Ink Holder(I/H) while carriage is shuttling.
The available settings are shown below.
Set item
Page size
Number of endurance
running cycles
Waiting interval
TIP
• If the number of endurance running cycles is set to -1, the carriage continuously repeats endurance
running until cancel input is given from the operation panel.
• The minimum configurable feeding amount is 50mm.
• The maximum counter value for endurance running cycles is 99999999 (up to 8-digit number). If the
number of cycles exceeds the maximum value, the counter is reset to 0.
• The waiting time is not modifiable.
Table 5-18 Set Items in Cutter Endurance Menu
Contents
Set the media feed amount per
endurance running cycle.
Set the number of endurance
running cycles
Set the waiting interval per
endurance running cycle
completion.
[Enter] key
[Enter] key
[Enter] key
[Enter] or [Cancel] key
RJ-901C/RJ-900C Maintenance Manual
Set value
50 to 3000
-1 to 10000
40
Page size
Endurance count
Check waiting time
Performing endurance
5-64
Remark
Unit: mm
Unit: sec.