RJ-901C/RJ-900C Maintenance Manual
Replacing
(3)
CR_ENC
1. Remove the cutter holder assembly.
2. Remove the CR_ENC assembly-retaining screw (pan-head screw with spring washer and flat washer M
×
3
8 W sems: 1pce).
3. Detach the cable from the three clamps.
4. Remove the CR_ENC assembly.
5. To reassemble the unit, reverse the removal procedure.
Replacing
(4)
P_EDGE Sensor
1. Remove the cutter holder assembly.
2. Remove the P_EDGE sensor assembly-retaining screw (M3
Assembly
Assembly
4-45
No.
Part name
1
Mounting plate screw
2
CR_ENC assembly
3
CR_ENC assembly screw
1
×
6, P tight cup: 1pce).
No.
Part name
1
P_EDGE sensor assembly
screw
2
P_EDGE sensor assembly
4 Parts Replacement