Lava Rock, Mineral Wool/Ember Placement; Install Trim And/Or Surround - Heat & Glo SL-550TR-E Installation Manual

E. Lava Rock, Mineral Wool/Ember Placement
WARNING! Risk of Explosion! Follow ember placement
instructions in manual. DO NOT place embers directly over
burner ports. Replace ember material annually. Improperly
placed embers interfere with proper burner operation.
Placing the Lava Rock
See Section 11.F for Lava Rock placement instructions.
• Place lava rock on base pan. Do NOT place on burner
top.
Placing the Ember Material
Ember material is shipped with this gas appliance. To place
the ember material:
• Embers CANNOT be placed directly over ports. See
Figure 11.3 for the only exception to this guideline. Care
should be taken not to cover the lighting trail of ports
(from back to front).
• When placing Glowing Embers
should be taken so that the ports are not covered. Place
the dime-size ember pieces near the port holes in the
burner top. See Figure 11.2. Failure to follow this pro-
cedure will likely cause lighting and sooting problems.
• Some of the small port holes should be covered with
ember material. See Figure 11.3 for detail.
• Save the remaining ember materials for use during appli-
ance servicing. The embers provided should be enough
for 3 to 5 applications.
NO EMBERS
Figure 11.2 Placement of Embers
PORT HOLES IN CIRCLED
AREA SHOULD BE COVERED
WITH EMBER MATERIAL. NO
OTHER PORT HOLES MAY
COME INTO CONTACT WITH
Figure 11.3
EMBER MATERIAL.
Heat & Glo • SL-550/750TR-E, SL-550/750/950TR-IPI-E Installation Manual • 2118-910 Rev. C • 4/16
onto the burner care
®
F. Install Trim and/or Surround
• Install optional trim kits and/or surrounds using the
instructions included with the accessory.
• Use non-combustible materials to cover the gap between
the sheet rock and the appliance (when applicable to the
model).
55