Table of Contents
Advertisement
E. Burner Top Installation
1. Bend the two tabs upward as shown in Figure 11.3.
2. To install the fiber burner, mate the locating holes with
the guide sleeves. Install fiber burner top so that it
makes full contact with the underlying burner assem-
bly.
3. Ensure that the ports in the steel burner are visible
through the holes in the fiber burner top.
FIBER BURNER TOP
BEND TABS UP
BURNER ASSEMBLY
GUIDE SLEEVES
Figure 11.3
F. Install the Refractory (Optional)
Optional fiber and black glass refractory kits are available for
use with the 6000C-IFT and 8000C-IFT models. Install ei-
ther the black glass refractory or brick refractory per instruc-
tions included with the kit.
60
LOCATING HOLES
AIR SCOOP
PILOT COVER
BURNER SHIELD
Heat & Glo • 6000C-IFT, 8000C-IFT Installation Manual • 2502-980 Rev. M • 3/21
G. Ember Placement
WARNING! Risk of Explosion! Follow ember placement
instructions in manual. DO NOT completely block burner
ports with ember material. Replace ember material annu-
ally. Improperly placed embers interfere with proper burner
operation.
Ember material is shipped with this gas appliance. To place
the ember material:
• Embers CANNOT completely block burner ports. Care
should be taken not to block the lighting trail of ports.
• Embers may only be placed in areas as shown in Figure
11.4.
• LP Only: Using dime-size pieces of Glowing Embers®,
overlap the burner ports as shown in Figure 11.5. The
impingement created by the embers will help blend the
fire.
• Save the remaining ember materials for use during
appliance servicing. The embers provided should be
enough for 3 to 5 applications.
EMBERS
Figure 11.4 Placement of Embers
Figure 11.5 Embers Overlapping Burner Port Holes (LP only).
NO EMBERS IN SHADED AREA
Advertisement
Table of Contents
